Fire Resistant Cabinets
Fire Resistant Cabinets are built for long lasting reliability and specially designed to withstand Temperatures up to 900oC for one hour. They are also built to withstand considerable impact in the event of the cabinet crashing through the floor in the course of a fire.
| FRC 2 | FRC 3 | FRC 4 | |
| External (mm) | 515W x 755D x 823H | 515W x 755D x 1186H | 515W x 755D x 1549H |
| Internal Drawer (mm) | 388W x 644D x 300H | 388W x 644D x 300H | 388W x 644D x 300H |
| Net Weight (kgs) | 175 | 260 | 340 |
| Shipping Dimension (mm) | 690W x 980D x 1040H | 690W x 980D x 1410H | 690W x 980D x 1770H |
| Shipping Volume (cu.m) | 0.70 | 0.95 | 1.20 |
| Gross Weight (kgsvv) | 213 | 309 | 400 |
WHEEL COMBINATION LOCK INSTRUCTIONS
Important Information :
Dialing to numbers must be accurate. Going pass the number and the backing up will prevent
the lock from opening(unlocking).
The Factory Pre-set Combination Numbers is 20 - 30 - 40
Opening (4-3-2-1 Turnings):
Step 1 :
Turn dial to the left (anti-clockwise) 1st number (20) to pass opening mark three times and stop on the fourth time.
Step 2
Turn dial to the right (clockwise) 2nd number (30) to pass opening mark two times and stop on the third time.
Step 3
Turn dial to the left (anti clockwise) 3rd number (40) to pass opening mark one time and stop on the second time.
Step 4
Turn dial to the right (clockwise) until dial stops completely (approx. between 95 & 0).The lock is now opened (unlocked). If dial turns more than one revolution, an error has been made, please start again from step 1.
Changing Of Combination Numbers
- To change the combination numbers you must first remove the existing numbers.
- Changing of combination numbers must be done with the safe door opened and the locking bolts thrown out. ( by means of locking the safe door while in opening position. )
- Dial the existing numbers as in the above steps 1-2-3, except that you line the numbers up at the change/setting mark (not center mark). Leave the final (third) number lined up with the change/setting mark.(stops at 3rd number)
- Insert change key (L shape key) into back of the lock through the opening provision behind the safe door, turn a quarter turn to the left (anti clockwise). The lock is now in a neutral position and ready to receive a new set of combination numbers.
Diagram or Change Key insertion:
Using the change/setting mark dial new number (1st number) as in step 1.
Using the change/setting mark dial new number (2nd number) as in step 2.
Using the change/setting mark dial new number (3rd number) as in step 3. Clockwise
Leave the last number (3rd number) lined up at the change/setting mark, Turn change key a quarter turn to the right (clockwise) and remove change key from the lock.
Test new combination numbers three times by following the Opening steps (4-3-2-1 turnings on opening mark).
Please do not use numbers below 25 for the last num
Back to Product Listing
